The alarm monitor M1000 is an alarm panel with 10 digital inputs. An input from a dry contact (normally open NO or normally closed NC) will cause a corresponding LED to flash.
This is second hand and limited stock product in good condition.
Famous model on market
The SELCO M1000 is an Alarm Monitor capable of surveying the state of up to 10 potential free contacts.
LED's flash codes
The first incoming alarm is indicated with a quick flashing light, following alarms are indicated with slow flashing light. LEDs will keep flashing until the alarms are acknowledged, even though the input signal has been deactivated. Pressing the RESET pushbutton will acknowledge all new alarms whereby all flashing LEDs will change to steady light, provided that the related inputs are still active. Pressing the RESET push button will also silence the siren. The reset sequence is programmable.
10 input channels with LED indication (NO or NC contacts)
10 programmable output channels
Paper label for alarm description
Special indication of first alarm
Programmable reset sequence
Built-in siren relay
RS232 based configuration
IP56 protection rating
Certified for marine use.
|Power Supply||:||24 VDC|
|Alarm input||:||n.o / n.c. contact|
|Relay||:||1 Relay / 220 VAC 2A|
|External alarm output||:||10 Corresponding outputs ( 150 mA max.)|
|Power consumption||:||Max 5 W|
|Connections||:||Capable of connecting up to 63 Units|
|Alarm delay||:||All inputs set from 0 to 100 second|
|Temperature range||:||-10 to +70°C|